@diynotaguy

A program which gives you maths practise specifically to prepare for the Senior Maths Challenge (SMC). It’s shipping a bit late for the 2026 challenge, but it might be helpful for one of the follow on rounds, or it can be used to practise for the 2027 challenge.

3D printed modular drawers where the drawers themselves are actually modular. Each module can be a draw by itself, combine with another draw on either side, or combine with a draw on both sides. This means that you can make an infinitely wide draw!

A joint software-3D printing project that uses your ps4 controller, phone & laptop to take and store a picture every time the triangle button is pressed. The hardware part is that the controller is held on the end of the Bambu Lab A1 mini x-axis rail by a 3D printed part. A 3D printed trigger arm is attached to the print head so that every time a layer is finished and the print head goes to the end of the x-axis rail, the triangle button is pressed and a photo is taken. The project should work on a Bambu Labs A1 as well, but I haven’t tested it.

A python document that you can run pigpython (pigpython) in. pigpy is essentially python but with all words translated into pig latin.

A tape dispenser integrated into gridfinity so that you can cut the tape without having to take it out of the draw. It also measures the tape length as you pull it.