Tetrapack
Hardware
By
@Kyuuby_
- 3 Devlogs
- 5 Total hours
I’m building a 9 keys, high polling rate macropad
I finished the PCB!
I finally connected the pads and pins and distanced equally the keys(and debugged), now everything is ready and i gotta code the firmware.
I continued building the schematic and pcb of Tetrapack:
- I’ve finished(for now) the schematic.
- I added a 0.91 inch OLED display, i did some research and found out that my rp2040-zero can handle it without problem.
- Started arranging the pcb components in the C.S. Editor.
And that’s it for today!
I started building my Macropad(Tetrapack)!
I researched a lot of things:
- what microcontroller/MCU i could use
- how to connect switch
