@koshi

I started working on a new project today, an interactive bookshelf where i can share books I’ve read and my reviews.
Today I got the project setup done, created the Github repo and finished the HTML layout.
Tomorrow I’ll start working on CSS file and will start building the actual bookshelf and the first book. Hopefully I’ll have something to show tomorrow.

Learning fusion 360 was really challenging, I took a huge break and didn’t work for days but my hackpad case is finally complete im going to work on Firmware now and ship my project.

I’m finally done with PCB layout and routing, routing the LEDs was a tough work then right after that I got 62 errors because of LED footprint board edge clearance violation ദ്ദി╥ ᴗ ╥) I wasted a lot of time trying to figure out how to fix those when i just had to ignore those errors lol. Anyways I also realised we had to use kicad time tracker which I stared using after my pcb was done lol so yeah it took a lot more time than it shows. I also added a cute bocchi graphic there.

Hello everyone koshi here! ( ˶ˆᗜˆ˵ ) This is my first devlog also my first hack club project. I’m making a macropad for the hackpad course and it has been really fun and exciting till now. I didn’t know anything about electronics and PCB so I spent the first two days just learning everything about it while also working on my schematic which is finally done. I ran into a small problem though, I was running short on 1 pin for the OLED display in the microcontroller so to solve that i sacrificed the push switch in the rotatory encoder now I can have everything, LEDs and OLED display along with rotatory encoder lol. Next step is working on the footprint. see you in the next Devlog!byee