@anasluqman089

Hello everyone! This is just a short one. I have launched the website using pythonanywhere. Here is the link to check it out https://lonos67.pythonanywhere.com . I havent post anything yet because Im a bit busy but I will post it

Decided to change the theme to aero futiger. Im very proud of what I did here but the background image looks very pixelated so I need to change that. Should I change the image to .svg?

Hello everyone I created LonoBlog. I added a public blog page with search, category filters, sorting, reading times and comments. Added doodles, rounded styling, Markdown formatting and emoji bars for writing and comments. I used a brown pallete.

The staff said to remove the capacitor, enlarge the hinge and edit the size holding the screen so I did that and I edit the file a bit in the repos

Devlog #5 Hello everyone! I have tweaked the design a bit and I have updated the repo

I have finished modelling and the hinge system.

Almost ready for submitting for funding

I have refined the design a bit but Im still continuing the locking mechanism

Devlog #7 Hello everyone! One of the staff has given me recommendations to change how the locker lock itself. I will now use hinges and tomorrow I will put a locking mechanism using the servo

Devlog #4 Hello everyone! The 3D is finished! I added a hole for the USB-C and the SD card. Created the lid and the half circle is for the keychain. that is all for today and I will submit it for funding very soon!

Devlog #3 Hello everyone! Today, I have have put the button upside down and shorten the PCB a bit. Im continuing on with 3D model and as you can see the corner is rounded to reduce force on impact. That is all from me today.

*Devlog #4 Hello everyone! Today I have finished the 3D model and I will submit to funding later.

Devlog #6 Hello everyone! Today I want to explain something about the phone section. The lid that is disconnected from the phone locker will be connected to the servo, so the servo can open it and close it. Then, the wire of the servo will go under the support and throught the hole and connected to the PCB. Finally, the phone locker section is connected to the alarm section. This means the alarm section and the phone locker section will be printed together but if the 3D printer printing margins is to small, the alarm section and the locker section will be printed separatedly and be glued by using a 3D pen but it will not looked as good. so that is all from me and also follow along my other projects.

Devlog 2 Hello everyone! today I have edited the PCB to fit all the parts so this is just a short devlog

Devlog 1 Hello everyone! Yesterday I was doomscrolling then I found a post about a Kodak keychain camera and i want to build it, I will be using a XIAO ESP32-S3 Sense, 3x 6mm pushbutton and a 1.3” IPS LCD screen .It will be powered with a Li-Po battery. I have finished the schematic and the PCB design need some tweak. so follow along my project even thought there are other project that I haven’t finished but I have submitted Blare Phone Locker for funding so also follow that project too!

Devlog 3 Hello everyone I have finished the PCB and will continue with CAD. I added BME280 just for fun

Devlog #5 Hello everyone today I continue on building the 3D model. There is a hole for the wire to connect to the servo. The locker is almost ready but I need to add the support for the servo and the lid but there is something bugging me. How should the alarm and the locker be connected? That is all for me see you again~~~~

Devlog 2 : continued building the PCB

DEVLOG #4 Hello everyone today I continued on building the 3D model but I decided to make the 3D model of the alarm and the phone locker separate, It so confusing using OnShape for me but I managed. As you can see below, thats the alarm. It only take 2 AND A HALF HOUR but it look so horrible but I will continue.