rustpad
- 2 Devlogs
- 1 Total hours
The macropad example, but in Rust and hopefully cooler. This is abandoned, as only QMK, KMK and ZMK are allowed.
I just read that only QMK, KMK and ZMK are allowed. This is… really sad. I despise C, but I guess I’ll have to use it.
Finished the designs for the PCB and the case. Importing the plate into FreeCAD was a hustle, but I managed to figure it out by reading through 6 year old blog posts.
I was surprised that the hackpad guide uses non-FOSS software, but well.
Onto the firmware!
