OMG OMG OMG
finally at the modeling stage. did some work yesterday but didnt remember to lapse it. this is THE final design, i have decided. added a small silkscreen and mounting holes (m3). added 3c models to kicad, to aid in 3d modeling. attempted to use fusion but it said my graphics driver needed to be updated, which i dont have time for rn. made a very simple box in onshape, to hold the pcb.

design going into modeling (this is mostly so i remember). id like to have the top exposed above the xiao, if i can print it id like a translucent portion above the leds, unsure about the screen. the scratch wheel is going to be a bit hard, as its quite close and (assuming a consistent diameter) will be 2 cm across (not good). my planned solution for this is to have half of it be short (to not interfere with the keys), and the other half be a suitable size (and hanging off the board)