@HarmanD approved your design ? · about 1 month ago

Great Work!

@HarmanD returned your funding request ? · about 1 month ago

Hi Great Work Here! Before i can approve this project you need to add your BOM as a .csv file as well! -Harman

Open comments for this post

@reaue on DragonMacroPad · about 1 month ago

1h 11m 51s logged

Devlog 5 - Finishing the firmware and the GitHub repo.

Today, I have finished everything before the shipping of my project. I had some issue with QMK due to incompatible version of different tools. But Everything are done well (I hope) now. Let’s ship it !

Open comments for this post

@reaue on DragonMacroPad · about 1 month ago

1h 47m logged

Devlog 4 - Finishing the case !

I have finished the case and fixing an issue with my led pin in the pcb. I’m happy with the design and hope I didn’t fail something which I will only realize when during the construction part. Now let set a GitHub and look for the firmware.

Open comments for this post

@reaue on DragonMacroPad · about 1 month ago

1h 49m logged

Devlog 3 - Creating bottom case.

After a lot of time of reflexion and test I finally happy with the bottom case I have created. Now, let’s build the top case.

Open comments for this post

@reaue on DragonMacroPad · about 1 month ago

1h 14m 43s logged

Devlog 2 - Finishing the pcb.

I think I can say I have finish my pcb design. Now let’s try fusion 360.

Open comments for this post

@reaue on DragonMacroPad · about 1 month ago

5h 32m 51s logged

Devlog 1 - Starting the macro pad.

I started with the desire of have 12 switches, 1 rotary encoder and olde display and led. But I can have only 11 pins, so after a night, I found a solution, use a matrix 3*3 with 8 switches and the push button of the rotary encoder. With that I need 11 pins so it’s good. Next I started the PCB in kicad, after one or two hours of trying to optimize the wiring. I lauch the CDR and like you can see on the screenshot I have a lot of problem. I admit I have so much idea how to cerrect them. I see that i can put and ground board and put led on the other side but flipped. I need to try ! If you had any idea I’m taker.