trypadhack

i remade the case hole for the usbc cable and reddesined the pcb

i made the chase and the 3d modell of the pcb with parts not sure if the 3d modell and footprint of the olead screen is right.

anyone know how to 3d design on FreeCad?
i hafe no idea what to do or anything the tutorial more confuses me then expected. anyone any advice?

WAR IS OVER i finally done the pcb now onto the case i just wanna get it over before stardance ends that means next few days quick 3d modelling then coding and then the github

at this point i guess i shuld ask in the slack

i hafe no idea what i hafe to do the drc manly complains about Plate edge free space violation

i hafe no idea what i am doing this stupid drc says everytime i do something wrong

i removed 3 leds so its easyer to connect them but once again the dumb drc says nope

i think i hafe an idea how it could work now

i dont know if its right or not ill just try

i need to start over i guess i noticed my planed parts and stuff was to much to fit the size i imagined and also the drc errors confiused me

i dont even know what i did i think i connected the leds with the seeduino and then run the drc wich gave me a lot of errors and warinings wich i dont understand
if anyone has a tip what i hafe to do i would really appreciate

PCB design is more complex then expected

i did the footprint assignment tool and then worked on the pcb design i didnt knew how i want it too look and when i wasnted to draw the connection i t didnt worked out so i am still on working on the pcb

Hi i think i am finally done with my scametic after last time i had problem with lapse i made a pause. i at first wanted to check everything i did then tried to organize it better after that i connected everything what wasnt connected found out i made a hole lot of dump mistakes wich i at first didnt knew what caused them but after asking a ki i found out and solved every error

i tried to get gemini explain matrix wiring to me but didnt worked out good then i tried to follow someone elses worke so i hafe a basis so i can personalize it frome then on. guess i need a lot more of trial and error.

it is the first time i ever tried myself on something like that i basecly followd the tutorial and then wanted to personalize it like you shuld do but because i never did something like that i tried to figure out what has to connect to what i know mostly of that is probaply wrong connected or so but i dint waned to ask ai instantly