i tried to make a boost converter for like 5 hours and it just didn’t work at all my guess is that it was do to the inductor. anyway i decided i will do that latter so i started working on sorting wires(fun) and while doing that i got ideas

usb:
so i learned this has a +5VSB and by found out i mean i actually read thought the data sheet like 30 hours in to this project and i want to add a usb port on it so i can power Arduinos my fume extractor and other things

-12V:
i original wrote this off because i hade a +12 but it turns out it is fun. and if it is there why not add another output it wont have a current sensor because it can only output up to 0.3A so why even bother

case:
i am going to have to make a new case because the current one cant fit everything so i am going to do that tomorrow and this should also allow for me to move where the rotory encoder it becouse before i put it in a bad spot becouse i didnt have space

boost:
i might switch the boost converter to the 12v rail idk yet just though i would menchin it