MediaPad

I have finally finished my Mediapad and sent a submission for it!

I’ve been also experimenting with a stand for the Mediapad via Claude MCP and tried to print it on my 3D printer, but it looks that for now we will not add a stand :D

I’ve also done few changes to the case and PCB.

Right now I am waiting until my submission passes through and it gets delivered to me so I can build it!

I had to completly redo the casing for my MediaPad because the old one wasn’t that good and also had issues with M3 screws where the dimensions were incorrect and it also wasn’t designed for heat inserts. This revision has correct dimensions for screws and heat inserts and also uses the latest layout of my PCB.

I have also redesigned the layout of my PCB as mentioned where I removed one mounting hole because I found out that it’d be better to use it for the case holding+PCB around the Hackpad than somewhere in center holding primary the PCB and making pressure at the 3D printed case at center (could lead to bends).

I have created a case & firmware for my Mediapad.
Becuase I am not really good at modeling, the case isn’t much but I think that it is my best work in Blender yet!

I just finished making PCB & Schematics. I am right now preparing to continue making Case and Firmware… Not really looking forward to making the case because modeling is the biggest pain for me that has ever existed.

I have just completed the basic tutorial for Hackpad but right after this I am going to begin to work on schematic for Spotify Board that will as the name may say… be for Spotify App control :)