I am building a multi use macropad, with 4 different modes, Gaming, School, Browsing, and Content Creation modes using a rotary encoder. The OLED displays the active mode and the RGB lighting changes colour depending on the mode.
Retracing the PCB to allocate for the dimension requirement
Just finished Wiring the PCB, have to say, this was the hardest part so far. I was compeltely stuck until I found out what Vias were
I arranged the PCB, but might rerrange based on how it looks
I just completed the schematic for all of the LEDs. Using LEDs made my life a lot easier, its auctually crazy.
Redoing the enitre schematic because I learned about labels and this helped me get rid of all the long ahh wires
Remaking Entire Schematic because lack of GPIO pins
I am removing some switches to make room for the rotary encoders in KiCad
I have just created the matrix wiring and layout for my PotatoPad, I am learning new things as I complete the project
