Connected the wires to the switches and the U1 in the pcb. Had some trouble with placing the the components in a position where all the wires could be connected. Then once I was done with both sides of the pcb, both the red and blue wires, I moved on to the DRC and checked for any errors. I had to change the shape of the pads from oval to circle and make them smaller on the U1, which is the MOUDLE-SEEEDUINO-XIAO, because they were touching the wires and that was an error. Another error I ran into was the wires being too close to components on the switches so i had to move them and make them slimmer because they were 0.2mm away from the components. I had an issue with pad 3 of the U1 and pad 2 of the 6th switch being extremely close so once I moved U1 I had to reconnect some of the wires again.