@thaimin01

Today, I assigned the footprint, do some quick changes, moving it from ISO to ANSI

Quick note: Due to being late on the Half Life event, the project was unfinished and it is going to be changed to the Stardance event by me

The schematic is almost done just some more debugging

Did some tweaks to the BOM and the csv gosh i hate exceling

STARDANCE IS EXTENDED

So i spend sometimes fixing my mistake for shipping and this is like the 5th times, 6th times maybe ?

Man, all i did was bullshitting around for a whole hour

WTH AM I DOING

So i decided to start coding today but it barely do anthing. All i did was #define the pins and.. ye thats it….

GUYS HELP

So i started coding today, just for it to be empty

AND WORSE
I DONT KHOW HOW TO CODE

I FINISHED THE PCB HOORAY !!111!

SPAGHETTI TRACING

IMBALANCE TRACE

VIAS SLOP

AND NOT GOING TO PASS THE EMC TEST

uhhh, I dont really khow what to say but the pcb routing is almost finished

Welcome people

To my high quality human slop

Spaghetti tracing

And i dont khow if it will work or not

YAY !1!!!11!!11!

What the hell ???

Which component goes to which component ???

I am kirkenuienly confused
💀💀💀💀💀

So I got a simple PCB layout today and connect most of the GND, Well it just that’s it

I didnt do anything much today rather than adding the auto detection for the micro sd card, and assigning 3d model for the footprint

So today i finished assigning footprint, tommorow imma give the chematic and footprint one more review then i can route the pcb

Uh, so i decided to ditch the bluetooth featur, use the 1.8 inch screen instaed and uh ye down grade from SDMMC 4bit to SDMMC 1bit since it save me some GPIO and Still have that fast speed

Pcb reviewing, added extra passive components and fixing error. Schematic almost done, boutta move to pcb designing

Hi there humans

SO today i finished routing the audio system and misc

and it almost done i am still having trouble finding screen that fits and comes with kicad asset

So today i decided to fix the case bacaus ethe clearence between the keycaps and the lid is too small

Don’t even joke lad

So, today I finally and finally move onto the routing, It was an actual nightmare because the power system was not easy and even the datasheet missing component for the example circuit but luckily gemini cam in to save the day

So today i finished finding all the needed assets for the project, after that i organized evrything to prepare for the routing tomorrow