I have finally begun 3D printing out my designs. But i’ve only started with the servo case which lowkey worked kinda on the first attempt except for the wire spacing and I probably need to figure a way to securely mount the motors. I attached how I currently secure both servo motors (as I’m writing this I realized I need to add outlet holes on both side as I need to reverse the top servo.

The reason it took so long is because I was trying to configure the design to a mg996r but then I realized I cant test the design… In the second image you can see the different parts rendered.

Im currently working on the clamp. Basically I realized mounting via screws would not work because the screw size is M2 and lowkey I don’t have a long enough screw to extend + im lowkey not bob the builder 😭😭

I attached the current 3d print I made for the servo case.