I have worked on the Schematic, PCB, and Case up to this point. A total of 23 hours has been put in due to the fact that I am brand new to making electronics and have had to search up how to do a lot (I did not know how to track my time outside of coding before this). I went through a lot of trial and error with schematics and PCBs. I went through 3 iterations of a schematic trying to see how I can optimize the number of pins I’m using while keeping 10 or 12 switches. I tried LEDs but they were causing many errors in the DRC. The LEDs were more hassle than function so i decided to go with my optimized 12 switches, OLED display, and Rotary Encoder with no switch capabilities. Below is my final interation of my PCB that was able to throw no errors.