I troubleshooted, assembled and tested the devboard.

When I got my devboard, I realised that it didn’t work because there were 2 3.3v nets and they were not being connected, after linking the 2 3.3v nets together using a bodge wire I realised that the devboard still wasn’t getting enough power as the 3.3v voltage regulator was only outputting 1.3v, I ended up using an Arduno Uno’s 3.3v pins + some jumper cables to provide power to the board.

In the end I was able to make the board work just fine without too many problems!!

here is a picture of the board in the end