9/18/2026 - 10th Update!

it’s like 1:43 AM, wasnt gonna write a log for today, but might as well? anyways, added a stack, hopefully i remember to make those actually tensioners later

6.540 cm vs 5.162 cm, we should be able to tension up to 1 cm with this setup?

hmm i really dont know how to do this setup, with two rods here? anyways, the corexy belts are added, just trying to get the tool base profile working? considering maybe using a linear rail here, or maybe even v wheels for the extrusion? (idk)

mfw looking for MGN9C models and the specs dont include data on the screw hole size for some reason

yeah uh the screw hole is bigger than the middle section of the extrusion, might have to use MGN7C at this point

well, after a bunch of research, i think using the rail is the method, though, im not sure exactly how we should use it. mounting it above an extrusion is probably the best setup here, except 10mm x 10mm rails are like super niche or something since basically no one sells them (pla t nuts cant be too bad… right?)

welp, not sure, not much cad updates today, mostly research?

also, the reason i didnt start earlier today was because i sorta fell asleep today for four hours in the afternoon after coming back from school, oops, anyways, it’s 2:42 AM now and yeah, good night!