Devlog #2
Big update this session. I finished routing all the parts, connecting the schematic and PCB fully. The first routing pass ended up pretty messy though, so I went back and rerouted everything properly, this time adding a proper GND pour and a small VCC pad for cleaner power distribution. While I was at it I also added a logo to the board for a nicer finishing touch, and did a final routing pass along with resizing the edge cuts to get the board outline dialed in. Ran a DRC in between too, which caught a few unconnected nets and duplicate via warnings that I cleaned up. To wrap things up, I 3D-printed a test plate to check that all the switches, encoders, and connectors actually fit before committing to the real PCB.

The board is looking a lot more solid now, both electrically and visually. Next step is finalizing everything and getting ready to order the PCB.