Devlog #9: I am back!! I remade the wings, which are hollow. — I figured the other wings had some problems (the upwards (dihedral) angle was too high, and this same angle wasn’t equally distributed throughout the wings, and the wings were hard to hollow because of the way they intersected the fuselage (the face at the start wasn’t flat, which complicated it)). — Made the new wings by using the same sketch on a different plane with an inclination of 6 degrees, then re-lofting the wings and finally using the “thicken” tool with a thickness of 0.6mm. — Next to do: add internal structures for support