Yeah so i imported, adjusted and assigned every component, and then added everything to the PCB
I then exported everything as a PDF and gave it to an LLM so it could look over it and point out any errors.
I had some minor errors, like some Pads not connected to GND when theyt should have been and a wrong capacitor value, but otherwise
im pretty proud of myself.

Next is to arrange the components on the PCB - also it got recommended to me by the AI
to use a 4 layer PCB, as that lets me dedicate a layer each to GND and POWER - so i have less traces, and no spider nest - cause otherwise EVERY
GND or +3V/+5V connection would need a trace.