So I officialy finished the hardware.I added a PIR sensor and an Ultrasonic sound sensor.I mapped all the pins and made a list of the components I used Arduino Uno R3
16x2 LCD Display HD44780
10k potentiometer
PIR Motion Sensor HC-SR501
Ultrasonic Sensor HC-SR04
SG90 Micro Servo Motor
Passive Piezo Buzzer
breadboard
jumper wires
220 ohm resistor
1000 ohm resistor
external 5V power supply…
Now I think I am ready for the code (I am NOT READY for this emotional roller coaster)I tested all the components so if anything goes wrpng I ’ll be sure it is a software problem. Also the Assistant might look cheap and too low quality. But it is all I can currently afford. Maybe, maybe if stardance gives me a 3d Printer all my projects will be professional (just kidding(not rly)).See you in the next dev log.