Hi! Right now I finished the rest of the PCB, I:

• Rounded off the corners (3mm fillet)
• Finished all routing and changed some traces to make everything work (I used ALOT of vias hope that isn’t an issue!)
• Ran DRC - 3 times - to make sure nothing goes wrong
• Repositioned the LED Pad for easier soldering

And I think that’s pretty much it! Oh yeah I crashed out a lot cz some traces were in the area of the LED which is the hole area (I can NOT speak rn) but u get the point like the hole that is cut out for the LED, over there, there were traces so i had to move them, then, some tracks were inside other tracks of totally different nets :heavysob: like I crashed out sm cz of this. Anyways, im done with my PCB i’ll just double check diode orientation (I can fix it later by soldering diodes other way around but i wanna make this easier for me) and then I’ll start working on the CAD. I hope I can use OnShape Hackatime instead of lapse cz i am tired of using lapse. Anyways, cyaaa!!!!

Lapse Link: https://lapse.hackclub.com/timelapse/jHSqlRHYnwNE