Devlog #1

Created the schematic for my macropad.
My macropad will feature a 3x2 grid of switches, and a knob alongside an OLED display. It’s my first stardance project and my first time designing a pcb, so I didn’t wanna do something too complex.
The rotary encoder and switch matrix were pretty simple, especially after looking at some projects from other people. But the OLED display is what I had the most trouble with. After running ERC, the same two error kept popping up. I forgot exactly what they said but it was something along the lines of “VCC isn’t connected to a power source” and the same message for GND(for some obscure reason??). I tried renaming the labels(before I switched to the 3V3 thingy, I just had labels wired to VCC and pin 12 of XIAO), switching them to different pins, changing the labels to 3V3s, etc. Turns out, all I had to do was add a PWR_FLAG to let KiCad know that there is power running there. After that, ERC showed no errors and i was satisfied with my schematic. Next on the checklist is routing the PCB.

P.S. I forgot to run kicad-hackatime from the start, so that’s why there is so little time logged.